How to Connect Your Aura Coil and Console to Your Resonant Power Kit Using Bluetooth Connection.Updated 2 years ago

Part 1: Connect Aura Coil to Resonant Power Kit

1. Connect the Power Cable to the Amplifier and to a power outlet.

2. Unscrew the “Binding Post Jack” (Red and Black screws on the Output Section)

3. Put the wires directly into each hole (Black Wire to Black Port and Red Wire to Red Port)

4. Tighten up the screws and pull slightly to check that wires are secure

5. Turn your Wireless Powerkit ON , press the “Power” button..(Red Light Indicator should light up)

Part 2A: Connecting Resonant Console to Resonant Power Kit

1. Pair with your console device by going to Settings-> Bluetooth then select “Resonant System” (The light indicator should turn from Red to Blue).

2. Open the Resonant Console app

3. Play the testing frequency

4. Turn up the volume on your Console to maximum

5. Turn up the volume on Power Kit to maximum

Part 3: Test Aura Coil for magnetic field

Step 3a: Hold the Gold Magnet close to the Aura Coil to test for magnet movement.

Step 3b hold the ball magnet near the Aura Coil to feel the vibrations in your hand

Optional

Play test frequency to feel a stronger magnet vibration 

Once the magnet test is successful, your Aura Coil system is ready to!

Note: Not all frequencies will move the magnet, only the TEST frequency and some lower frequencies will move the magnet.  The Aura Coil are still working even if you don't feel/see the magnet move for some (higher) frequencies.

Make sure the testing frequency is playing during the test, it is only 1 minute long, so just play it again when it stops.

For normal operation, do not turn the volume knob pass the 3 o’clock position (75%) to avoid overheating.

Still Not Working? 

Repeat the steps above and make sure cables are properly connected, volumes are turned up and amplifier and console power is turned on, and test frequency is playing.

Magnet Not Moving?

Watch this Troubleshooting Guide