Qi Life Store logo
Qi Life Store logo

All articles

How to Connect Your Qi Coil and Braintap at the Same Time with Your Console and Wireless Power Kit (WIRED)Updated 2 years ago

  1. Connect the Resonant Console to the Wireless power kit with an Auxillary Cable.

  2. Connect wireless mobile power kit to splitter audio jack

  3. Connect one end of the splitter to the Braintap Headset.

  4. Connect the other end of the splitter to Qi coil.

  5. Turn your Wireless Powerkit Volume clockwise to Power ON. Turn knob clockwise to full volume.

  6. Turn on the Braintap headset by switching button from OFF to ON.

  7. Enable Bluetooth by turning the switch from BTH to AUX.

  8. Open the Resonant Console App

  9. Play the testing frequency

  10. Turn up the volume on your device to maximum

  11. Hold the gold magnet and get it close to the Qi Coil to test for vibrations.

  12. Alternatively. Hold the small magnet in the plastic jar close to the Qi Coil to test for magnet movement.

  13. Test if Braintap headset is working. Play "Remove Negative Energy" frequency on the app

  14. You should be able to hear sounds on both sides of the earmuffs.

  15. Qi Coil not working? Check mobile power kit is charged, or connect it to a USB port with the USB cable

  16. Braintap not working? Check if headset is fully charged or connected properly to the splitter and mobile power kit.

Important! Most people don't need to turn the mobile power kits to 100% volume during normal operation.  50% volume is adequate for most people.

Once the magnet moves and your Braintap is working, then you’re ready to go!

Note: Not all frequencies will move the magnet, only the TEST frequency and some lower frequencies will move the magnet.  The Qi Coils are still working even if you don't feel/see the magnet move for some (higher) frequencies.

Play your chosen frequency and start experiencing qi energy!

Magnet Not Moving?

Watch this Troubleshooting Guide

Was this article helpful?