How to Connect Your Resonant Console to Resonant Wand with Resonant Power Kit via BluetoothUpdated a year ago

Part 1: Connect Resonant Wand’s to Resonant Power Kit

1. Connect the Power Cable to the Amplifier and to a power outlet.

2. Unscrew the “Binding Post Jack” (Red and Black screws on the Output Section)

3. Put the wires directly into each hole (Black Wire to Black Port and Red Wire to Red Port)

4. Tighten up the screws and pull slightly to check that wires are secure

5. Turn your Wireless Powerkit ON , press the “Power” button..(Red Light Indicator should light up)

Part 2: Connecting Resonant Console to Resonant Power Kit

1. Pair with your console device by going to Settings-> Bluetooth then select “Resonant System” (The light indicator should turn from Red to Bluetooth).

2. Open the Resonant Console app

3. Play the testing frequency

4. Turn up the volume on your Console to maximum

5. Turn up the volume on Power Kit to maximum

Part 3: Testing the Resonant Wand for Magnetic Field

1. Hold the small magnet in the plastic jar close to the Resonant Wand to test for magnet movement. Avoid holding the cylinder magnet near the face, to avoid it from snapping onto the sapphire lens.

2. Not working? Check power kit Cables are connected properly. Try reconnecting the Wand’s Cable at the back of the binding posts. You can also check if the bluetooth is successfully connected to the right bluetooth audio media and if no other bluetooth media is connected to your console.

3. Replay the testing frequency, or try "life force mid" frequency on the app

4. Important! Most people don't need to turn the Power kit to 100% volume during normal operation.  50% volume is adequate for most people Note: Make sure the testing frequency is playing during the test, it is only 1 minute long, so just play it again when it stops. For normal operation, do not turn the volume knob pass the 3 o’clock position (75%) to avoid overheating.

Once the magnet test is successful, your Resonant Wand System is ready to go!

Note: Not all frequencies will move the magnet, only the TEST frequency and some lower frequencies will move the magnet.  The Wand is still working even if you don't feel/see the magnet move for some (higher) frequencies.

Play your chosen frequency and start experiencing qi energy!

Magnet Not Moving?

Watch this Troubleshooting Guide